SIMAGIC EVO Installation Guide

1

Assemble Dedicated Bracket

Assemble the dedicated bracket. Features: M8 angle adjustment screw, mounting slots suitable for 30/40 profile. Upper and lower mounting holes can adjust base height.

💡 Lower mounting gives greater bracket tilt angle

M8 Angle Adjustment Screw

2

Fix the Base

Fix with 4 M6 screws at the bottom of the base, use the lowest mounting holes, adjust the fixing bracket to the lowest position.

M6 Screw Position

3

Remove Quick Release

Use the yellow T-wrench included with the wheel to remove the EVO quick release, prepare a flathead screwdriver to open the communication port.

Quick Release Removal Position

4

Install Extension Shaft

Insert the extension shaft, replace with longer screws.

Extension Shaft Position

5

Connect Data Cable

Reconnect the data cable, CN2 and CN1 ports. Align the four springs with the four support points and reinstall.

💡 Pay attention to installation direction, align with quick release, quick release has 6 ball holes on top and 4 on bottom, SIMAGIC logo at top

CN1 Port

CN2 Port

6

Position the Cam

Attach the cam on the left side of the shaft, note position: horizontal left position. Only attach one, do not attach at other angles.

⚠️ Use rubber band to help fix for 7 days to ensure secure adhesion

Cam Attachment Position

7

Install BlackHole Module

Insert the BlackHole module, tighten the fixing screws at the back.

BlackHole Module Position

8

Fine-tune Position

The BlackHole module can be fine-tuned left and right to improve lever trigger reset sensitivity.

Adjustment Range